A级爱爱片欧美

<ruby id="5rvdv"><thead id="5rvdv"></thead></ruby>

<pre id="5rvdv"></pre>

<big id="5rvdv"><big id="5rvdv"></big></big>

    <ol id="5rvdv"><font id="5rvdv"><ins id="5rvdv"></ins></font></ol>

        <pre id="5rvdv"></pre>

          <sub id="5rvdv"></sub>
          FOR QUOTES AND ORDERS PLEASE CALL 1-800-547-1091 OR
          PMTSCO

          < RETURN TO TOOL & DIE STEEL

          Trucks

          A-6 Annealed

          Tool & Die Steel PRODUCT

          PACIFIC A6 can be hardened from relatively low temperatures which results in low residual stress and reduced chances for distortion. A6 has lower carbon content than A2 and is alloyed primarily with manganese instead of chromium. Therefore, A6 is tougher but has lower wear and temper resistance.


          CHEMICAL COMPOSITION
          Heat Analysis - ranges and limits %

          C
          .70
          Mn
          2.00
          Cr
          1.00
          Mo
          1.25

          FORGING:
          Heat slowly to 1900/2050°F, do not forge below 1600°F.

          ANNEALING:
          Heat slowly to 1350/1375°F, then cool at a maximum rate of 25°F per hour to 1000°F (faster cooling rates can be used below 1000°F). Typical annealed hardness is 217/248 HB.

          STRESS RELIEVING:
          Heat to 1250/1300°F and hold for 1 hour minimum at temperature; cool in air.

          HARDENING:
          Preheat at 1200°F. Austenitize at 1525/1600°F for 20 minutes (for small tools) to 45 minutes (for large tools). Air cool to harden; typical as quenched hardness is 59/63 HRC.

          TEMPERING (Drawing):
          Temper immediately after the tool has cooled to 120/150°F. Typical tempering range is 300/800°F. Double tempering is suggested (cool to room temperature after the first temper).


          Tempering Temperature oF
          Approximate Hardness, HRC
          AQ
          61/62
          350
          61/62
          400
          60/61
          450
          58/59
          500
          58/60
          600
          56/57
          700
          55/56
          800
          54/55
          900
          52/53
          1000
          50/51
          1100
          48/49

          Shapes and Conditions Available
          Annealed Rounds through 3" Diameter
          SE? Flats & Squares from 1/2" through 2-1/2" Thickness

          A级爱爱片欧美

          <ruby id="5rvdv"><thead id="5rvdv"></thead></ruby>

          <pre id="5rvdv"></pre>

          <big id="5rvdv"><big id="5rvdv"></big></big>

            <ol id="5rvdv"><font id="5rvdv"><ins id="5rvdv"></ins></font></ol>

                <pre id="5rvdv"></pre>

                  <sub id="5rvdv"></sub>